samsung series 9 tumble dryer manual

The Samsung Series 9 Tumble Dryer is a high-efficiency heat pump dryer featuring advanced sensor drying technology, multiple drying cycles for various fabrics, a large capacity drum, reversible door, child lock, filter cleaning indicator, and energy-saving modes. Designed for 220-240V AC, 50Hz operation. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting to Utilities 7. Operating Cycles 8. Safety Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Heat pump system, LED control panel, large capacity drum, lint filter, reversible door, condenser unit, water container.

Feature	Description
Heat Pump Technology	Energy-efficient drying using recycled heat
Sensor Dry	Automatically detects moisture levels and adjusts drying time
Multiple Drying Programs	Cotton, Synthetic, Delicate, Wool, Anti-Crease, Time Dry
Reversible Door	Can be hinged on left or right side
Child Lock	Prevents accidental program changes during operation
Filter Cleaning Indicator	LED alert when lint filter needs cleaning
Delay Start	Program start can be delayed up to 24 hours
Anti-Crease Function	Tumbles periodically after cycle to reduce wrinkles
End of Cycle Signal	Audible alert when drying is complete
Energy Rating	A+++ energy efficiency class

Installation

Unpack and inspect contents. Place on level, stable floor.

Remove transit bolts: Locate and remove all transit bolts at the rear using spanner.
Position dryer: Ensure minimum clearances (5cm sides, 10cm rear, 100cm front).
Level the appliance: Adjust front feet to ensure dryer is level.
Ventilation: Ensure adequate room ventilation if not using vent hose.
Connect to power: Plug into dedicated 220-240V, 50Hz grounded outlet.

WARNING! Do not install behind a lockable door or in areas below 5°C. Ensure transit bolts are removed before use.

First-Time Setup

Plug in dryer; follow initial setup procedure.

Check filter: Ensure lint filter is clean and properly seated.
Select language: Press and hold Start/Pause for 3 seconds to access language menu.
Run calibration cycle: Run empty on Cotton cycle at high temperature for 30 minutes.
Set preferences: Configure end signal volume, default temperature, and child lock via settings menu.

CAUTION! Ensure the dryer is level to prevent excessive vibration and noise.

Specifications

Capacity: 9 kg (dry cotton).
Technology: Heat Pump.
Energy Class: A+++.
Power Supply: 220-240V AC, 50Hz.
Power Consumption: Approx. 1.5 kWh per cycle (Cotton).
Noise Level: 65 dB(A).
Dimensions (HxWxD): 85cm x 60cm x 62cm.
Weight: 45 kg.
Programs: Cotton, Synthetic, Delicate, Wool, Quick Dry, Time Dry, Anti-Crease.
Special Features: Sensor Dry, Delay Start, Child Lock, Reversible Door.

Controls and Settings

Access settings via rotary program selector and touch buttons.

Control Panel: Rotary Program Selector, Start/Pause, Delay Start, Anti-Crease, Child Lock, Temperature, Dryness Level.

Programs: Select via rotary dial (Cotton, Synthetics, Delicates, Wool, Time Dry). Settings: Temperature (High, Medium, Low, Extra Low), Dryness Level (Cupboard Dry, Iron Dry, Extra Dry), Delay Start (1-24 hrs), Anti-Crease (On/Off). Options: Child Lock (press and hold Child Lock for 3 seconds), Signal Volume (High/Low/Off), Reset Filter Indicator.

Connecting to Utilities

Power: Dedicated grounded outlet. Condensation: Empty water container or connect drain hose.

Turn off power at mains before making any connections.
For permanent drain: Connect supplied hose to drain outlet at rear.
Ensure water container is empty before each cycle if not using drain hose.
Check that vent grille is not obstructed.

Tip: For best efficiency, clean lint filter before every load and ensure room temperature is above 5°C.

Operating Cycles

Supports various fabric types and drying needs.

Load laundry: Do not exceed maximum load capacity (9 kg).
Select program: Turn rotary dial to desired program.
Adjust settings: Set temperature, dryness level, and options as needed.
Start: Press Start/Pause button.
During cycle: You can pause to add or remove items.
After cycle: Remove laundry immediately to reduce wrinkling; clean lint filter.
Empty water container: If not using drain hose, empty after each cycle.

WARNING! Do not dry items contaminated with flammable substances. Ensure zippers are closed and pockets empty.

Safety Features

Child Lock: Prevents program changes during operation. Overheat Protection: Automatically shuts off heating element if temperature exceeds safe limit. Door Safety Switch: Stops drum when door is opened.

Care & Cleaning

Unplug before cleaning. Clean lint filter after every cycle. Wipe exterior with damp cloth; do not use abrasive cleaners.

Monthly Maintenance: Clean condenser unit (refer to manual). Check and clean venting system if used.

CAUTION! Never operate without lint filter. Do not use steam cleaners.

Regulatory Information

CE Compliant: Meets European safety and EMC directives. Energy Label: A+++ according to EU regulation 392/2012. Waste Electrical and Electronic Equipment (WEEE): Do not dispose with household waste. For support, visit www.samsung.com/support or contact your local Samsung service center.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Dryer does not start	Door not closed/power	Ensure door is firmly closed; check power outlet and fuse.
Drying time too long	Filter/vent blocked	Clean lint filter; check condenser unit; ensure room temp >5°C.
Unusual noise	Foreign objects/transit bolts	Check for coins/objects in drum; ensure transit bolts removed.
Error code displayed	Sensor/component fault	Refer to error code list in manual; reset by unplugging for 1 minute.
Laundry still damp	Overloaded/incorrect program	Reduce load size; select higher temperature or longer time.
Water container full light	Container full	Empty water container; ensure drain hose is not kinked if used.

Reset: Unplug for 1 minute to reset electronic control.

Service: Contact Samsung Support or authorized service center.