Samsung Dryer DV350AEW XAA Manual

The Samsung DV350AEW XAA is a high-capacity electric dryer featuring advanced drying technologies, multiple drying cycles, sensor drying, wrinkle prevention options, and energy-saving modes. This manual provides essential information for safety, installation, operation, maintenance, and troubleshooting of your Samsung dryer.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting to Power & Venting 7. Using Drying Cycles 8. Care & Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Control panel with digital display, lint filter, drum light, exhaust vent, and power cord connection.

Feature	Description
Sensor Dry	Automatically detects moisture levels for optimal drying
Wrinkle Prevent	Tumbles clothes periodically after cycle ends to reduce wrinkles
Multiple Cycles	Cotton, Permanent Press, Delicates, Quick Dry, and more
Steam Refresh	Reduces wrinkles and odors without washing
Energy Saver	Uses lower heat settings to save energy
Child Lock	Prevents accidental changes to settings
End of Cycle Signal	Audible alert when drying is complete
Large Capacity Drum	Accommodates large laundry loads
Digital Display	Shows cycle time, settings, and status messages
Delay Start	Allows you to set dryer to start at a later time

Installation

Unpack and inspect contents. Place on a level, stable surface near a power outlet and venting location.

Remove shipping materials: Take off all tape, brackets, and foam from inside and outside the dryer.
Connect exhaust vent: Use a 4-inch diameter rigid metal duct to connect dryer to exterior vent.
Level the dryer: Adjust leveling feet to ensure dryer is stable and does not rock.
Plug into power outlet: Use a dedicated 240V outlet; do not use an extension cord.

WARNING! Dryer is heavy; use two people for moving and installation. Ensure proper venting to prevent fire hazard.

First-Time Setup

After installation, perform initial setup before first use.

Clean lint filter: Remove and clean the lint filter before first load.
Run empty cycle: Run a quick drying cycle to remove any dust or residues.
Set preferences: Use control panel to set language, signal volume, and default options.
Load laundry: Do not overload; follow capacity guidelines for best results.

CAUTION! Ensure dryer is properly leveled and venting is secure before operation.

Specifications

Model: DV350AEW XAA
Type: Electric Dryer
Capacity: 7.4 cubic feet
Power Requirements: 240V, 60Hz
Drying Cycles: Sensor Dry, Timed Dry, Wrinkle Prevent, Steam Refresh, Delicates, Heavy Duty
Control Type: Electronic with digital display
Dimensions (HxWxD): 44.5" x 29.5" x 32.5"
Weight: 125 lbs
Vent Type: 4-inch rear exhaust
Color: White

Controls and Settings

Control Panel: POWER, CYCLE SELECTOR, OPTIONS, START/PAUSE, CHILD LOCK, SIGNAL.

Cycle Selection: Turn cycle selector to choose drying program (Cotton, Permanent Press, Delicates, etc.).

Options: Wrinkle Prevent, Signal Volume, Delay Start, Energy Saver, Steam Refresh (if equipped).

Settings: Use OPTIONS button to adjust dryness level, temperature, and time settings. Child Lock: Press and hold CHILD LOCK for 3 seconds to enable/disable.

Connecting to Power & Venting

Power: Dedicated 240V outlet. Venting: 4-inch rigid metal duct to exterior.

Turn off power at circuit breaker before connecting dryer.
Connect power cord to terminal block (follow wiring diagram).
Secure exhaust vent to dryer rear and route to outside wall or roof vent.
Ensure vent is straight and short as possible; avoid sharp bends.

Tip: Clean lint from vent system annually to maintain efficiency and safety.

Using Drying Cycles

Supports various fabrics and drying needs.

Load laundry: Place sorted laundry into drum; do not overload.
Select cycle: Turn cycle selector to desired program (e.g., Cotton, Delicates).
Set options: Press OPTIONS to adjust temperature, dryness level, or time.
Start: Press START/PAUSE to begin drying.
Monitor: Display shows remaining time; Sensor Dry adjusts time automatically.
End of cycle: Signal sounds; Wrinkle Prevent may activate.
Unload promptly: Remove laundry immediately to minimize wrinkles.

WARNING! Clean lint filter before every load. Do not dry items contaminated with chemicals or flammable substances.

Care & Maintenance

Regular maintenance ensures optimal performance and safety.

Lint Filter: Clean before every load; wash with warm water monthly.
Exhaust Vent: Inspect and clean annually to prevent lint buildup.
Exterior: Wipe with damp cloth; do not use abrasive cleaners.
Drum: Wipe with soft cloth to remove lint or residues.

CAUTION! Unplug dryer before cleaning. Never use harsh chemicals or steam cleaners.

Regulatory Information

UL Listed; complies with U.S. safety standards. Energy Star certified (if applicable). Manufactured by Samsung Electronics America, Inc. For support, visit www.samsung.com/us/support or contact 1-800-SAMSUNG (1-800-726-7864).

Troubleshooting

Symptom	Possible Cause	Corrective Action
Dryer won't start	Power issue, door not closed	Check circuit breaker; ensure door is fully closed; press START firmly.
Clothes not drying	Lint filter clogged, vent blocked	Clean lint filter; check vent for obstructions; select correct cycle.
Dryer is noisy	Foreign object in drum, unbalanced load	Check for coins or objects; redistribute load evenly.
Error code on display	Sensor issue, overheating	Refer to error code chart in manual; reset dryer by unplugging for 1 minute.
Dryer stops mid-cycle	Overheating, power fluctuation	Clean lint filter and vent; check power supply; restart cycle.

Reset: Unplug dryer for 1 minute to reset control board.

Service: 1-800-SAMSUNG; www.samsung.com/us/support