Samsung Clothes Dryer Owners Manual

The Samsung Clothes Dryer is a high-efficiency electric or gas dryer featuring multiple drying cycles, sensor drying technology, wrinkle prevention options, steam refresh, and energy-saving modes. Designed for household use, it includes safety features, child lock, and digital controls. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting to Utilities 7. Operating the Dryer 8. Special Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Control Panel, Drum, Lint Filter, Exhaust Vent, Power Cord or Gas Line Connection, Door, and Start Button.

Feature	Description
Sensor Dry	Automatically detects moisture levels and adjusts drying time
Multiple Cycles	Cotton, Permanent Press, Delicates, Quick Dry, Heavy Duty
Wrinkle Prevent	Tumbles clothes periodically after cycle ends to reduce wrinkles
Steam Refresh	Reduces wrinkles and odors without a full wash cycle
Child Lock	Locks control panel to prevent accidental changes
Energy Saver	Reduces energy consumption by using lower heat settings
Delay Start	Allows you to set a time for the dryer to begin automatically
End of Cycle Signal	Audible alert when drying is complete
Drum Light	Interior light for easy loading and unloading
Venting Options	Configurable for rear or bottom exhaust

Installation

Unpack and inspect contents. Place on a level, stable floor near a proper power outlet and venting location.

Choose location: Ensure adequate clearance for air circulation and door opening.
Connect exhaust vent: Use rigid or flexible metal ducting (not plastic) to vent outdoors.
Electrical connection: For electric models, plug into dedicated 240V outlet. For gas models, connect to gas supply line with shut-off valve.
Level the dryer: Adjust leveling feet to prevent vibration and noise.

WARNING! Dryer is heavy; use two people for moving. Ensure all connections are secure and comply with local codes. Gas connections must be performed by a qualified technician.

First-Time Setup

After installation, perform initial setup before first use.

Remove shipping materials: Check drum and interior for packing bolts or foam; remove all.
Clean lint filter: Install lint filter in its slot.
Run a test cycle: Run an empty cycle on "Cotton" with high heat for 20 minutes to burn off any manufacturing residues.
Set preferences: Use control panel to set language, time, and signal volume.

CAUTION! Do not skip the test cycle. Ensure the area is well-ventilated during first use.

Specifications

Type: Electric or Gas Vented Dryer.
Capacity: 7.4 cu. ft. (typical).
Power Requirements (Electric): 240V AC, 60Hz, 30 Amp circuit.
Power Requirements (Gas): 120V AC, 60Hz for controls; Natural Gas or LP.
Control Type: Digital Touchpad with LED Display.
Drum Material: Stainless Steel.
Noise Level: < 70 dB (typical).
Dimensions (HxWxD): Approximately 44" x 29" x 32".
Weight: Approximately 130 lbs.
Warranty: 1-year full warranty, 10-year limited drum warranty.

Controls and Settings

Access settings via the control panel. Main Buttons: POWER, START/PAUSE, CYCLE SELECTOR, TEMPERATURE, OPTIONS.

Display: Shows selected cycle, time remaining, temperature, and status messages.

Cycle Selection: COTTON, PERMANENT PRESS, DELICATES, QUICK DRY, BEDDING, SANITIZE, AIR FLUFF. Temperature Settings: High, Medium, Low, No Heat. Options: Wrinkle Prevent, Delay Start, Signal Volume, Child Lock, Energy Saver. Settings Menu: Language, Time of Day, Factory Reset.

Connecting to Utilities

Electric: Dedicated 240V outlet. Gas: Approved gas line with shut-off valve. Venting: 4-inch diameter duct to outside.

Turn off power/gas supply at main before connecting.
Use proper connectors and sealants (gas tape for gas lines).
Ensure exhaust vent is as short and straight as possible for optimal performance.
Check for leaks (gas models) using soapy water solution.

Tip: Have a professional install gas lines and electrical connections if you are not qualified.

Operating the Dryer

Supports various fabric types and load sizes.

Load clothes: Do not overload; leave space for tumbling.
Select cycle: Choose based on fabric type (e.g., Cotton for towels).
Select temperature: Match to fabric care labels.
Add options: Select Wrinkle Prevent, Delay Start if desired.
Start: Press START/PAUSE. The display will show time remaining.
Pause/Stop: Press START/PAUSE to pause; press again to resume. To cancel, hold button for 3 seconds.
Unload promptly: Remove clothes immediately after cycle ends to minimize wrinkles.
Clean lint filter: Clean before or after every load.

WARNING! Do not dry items contaminated with flammable substances. Clean lint filter regularly to prevent fire hazard.

Special Features

Sensor Dry: Automatically stops when clothes are dry. Steam Refresh: Use for lightly worn clothes; adds approximately 20 minutes. Sanitize Cycle: Uses high heat to reduce allergens and bacteria. Child Lock: Press and hold CHILD LOCK for 3 seconds to enable/disable.

Care & Cleaning

Unplug or disconnect power before cleaning.

Lint filter: Clean after every load by rinsing under water and drying completely.
Exhaust vent: Inspect and clean annually to maintain airflow and efficiency.
Exterior: Wipe with a soft, damp cloth. Do not use abrasive cleaners.
Drum: Wipe with a damp cloth to remove any residue.

CAUTION! Never operate the dryer without the lint filter in place. Do not use solvents or spray cleaners inside the drum.

Regulatory Information

UL Listed; complies with U.S. safety standards. Energy Star certified on select models. For gas models, ANSI Z21.5.1 compliant. Copyright © Samsung Electronics. For support, visit www.samsung.com/us/support or contact 1-800-SAMSUNG (1-800-726-7864).

Troubleshooting

Symptom	Possible Cause	Corrective Action
Dryer won't start	Door open, power issue, child lock	Ensure door is closed; check power cord/outlet; disable child lock.
Clothes not drying	Lint filter clogged, vent blocked, incorrect cycle	Clean lint filter; check exhaust vent for obstructions; select proper cycle/temp.
Dryer is noisy	Unlevel, foreign object in drum, worn rollers	Level the dryer; check drum for objects; contact service for worn parts.
Error code on display	Sensor fault, overheating, communication error	Refer to error code chart in manual; unplug for 5 minutes, then retry.
Gas smell (gas models)	Gas leak, improper ignition	Turn off gas supply immediately; ventilate area; contact qualified technician.

Reset: Unplug dryer for 5 minutes, then plug back in.

Service: 1-800-SAMSUNG; www.samsung.com/us/support